| ??? 06/12/13 00:59 Modified: 06/12/13 02:08 Read: times |
#189926 - Power Down ? Responding to: ???'s previous message |
Mikkel C. Simonsen said:
What is Icc in Idle, with XTAL1 pin held H/L ? With the clock on, the current is 2.64mA. I tried disconnecting Vcc from the oscillator - the current drops to 0.98mA. That includes the Regulator, and pin-loads ? What value did deep power down (PCON=2) give ? Edit: **** Use caution if testing with your 450V regulator ***** The circuit they give, needs 300uA load, so a PDOWN LP device, will over-voltage (and probably not survive too well..) Once it is in idle, tie the Xtal1 pin to GND & Vcc and check Icc. That will give the 0MHz Idle current, usually == Flash-Enabled Data curves suggest core-only Icc in Idle, 0MHz is something under 0.5mA, so you are getting closer to that. Some vendors give a Icc formula which helps in situations like this. Mikkel C. Simonsen said:
So the solution is simple - run the LP214 with no clock at all! ;) :) |
| Topic | Author | Date |
| Low-power MCU needed | 01/01/70 00:00 | |
| OK, but wrong | 01/01/70 00:00 | |
| Wrong how? | 01/01/70 00:00 | |
| Silabs options | 01/01/70 00:00 | |
| C8051F99x | 01/01/70 00:00 | |
| Silabs | 01/01/70 00:00 | |
| look it up | 01/01/70 00:00 | |
| Looked up | 01/01/70 00:00 | |
| f53, no | 01/01/70 00:00 | |
| C8051F537A is OK | 01/01/70 00:00 | |
| the current in active mode is not the issue | 01/01/70 00:00 | |
| Inactive current | 01/01/70 00:00 | |
| re: wrong | 01/01/70 00:00 | |
| Consumers | 01/01/70 00:00 | |
| Zilog Z51F0410 | 01/01/70 00:00 | |
| Zilog | 01/01/70 00:00 | |
| Check you are entering idle ? | 01/01/70 00:00 | |
| idle current | 01/01/70 00:00 | |
| Idle test | 01/01/70 00:00 | |
| re: | 01/01/70 00:00 | |
| It floats! It floats! | 01/01/70 00:00 | |
| re:floats | 01/01/70 00:00 | |
| re:floats | 01/01/70 00:00 | |
| Timers | 01/01/70 00:00 | |
| More idle tests | 01/01/70 00:00 | |
| Better regulator? | 01/01/70 00:00 | |
| LR8K4 450V regulator | 01/01/70 00:00 | |
| also try CLKREG | 01/01/70 00:00 | |
| Clk Dividers are a good idea | 01/01/70 00:00 | |
| No dividers | 01/01/70 00:00 | |
| LP52 is cheaper too... | 01/01/70 00:00 | |
| LP52 | 01/01/70 00:00 | |
| No GND pin? | 01/01/70 00:00 | |
| re:idle | 01/01/70 00:00 | |
| Totally idle | 01/01/70 00:00 | |
| Checks | 01/01/70 00:00 | |
| More checks | 01/01/70 00:00 | |
| Power Down ? | 01/01/70 00:00 | |
| test setup | 01/01/70 00:00 | |
| STC | 01/01/70 00:00 | |
| C8051F86x/85x ? | 01/01/70 00:00 | |
| Maybe not such a good choice, after all? | 01/01/70 00:00 | |
| Support? | 01/01/70 00:00 | |
'51 support | 01/01/70 00:00 |