Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
08/21/02 20:55
Read: times


 		 #27664 - RE: declaring variables and registers
If I wanted to place the contents of the accumulator in R0 from bank 1, could I

MOV 08H, A
yes; however normally you would change the bank select in the PSW sfr (see the 80C51 family programmer's guide and instruction set pg5)

Erik

List of 19 messages in thread
TopicAuthorDate
declaring variables and registers            01/01/70 00:00      
RE: declaring variables and registers            01/01/70 00:00      
RE: declaring variables and registers            01/01/70 00:00      
RE: declaring variables and registers            01/01/70 00:00      
RE: declaring variables and registers            01/01/70 00:00      
RE: declaring variables and registers            01/01/70 00:00      
RE: declaring variables and registers            01/01/70 00:00      
RE: declaring variables and registers            01/01/70 00:00      
RE: declaring variables and registers            01/01/70 00:00      
RE: declaring variables and registers            01/01/70 00:00      
RE: declaring variables and registers            01/01/70 00:00      
RE: declaring variables and registers            01/01/70 00:00      
RE: declaring variables and registers            01/01/70 00:00      
RE: declaring variables and registers            01/01/70 00:00      
RE: declaring variables and registers            01/01/70 00:00      
RE: declaring variables and registers            01/01/70 00:00      
RE: declaring variables and registers            01/01/70 00:00      
RE: declaring variables and registers            01/01/70 00:00      
RE: declaring variables and registers            01/01/70 00:00      

Back to Subject List