Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
04/06/03 07:14
Read: times


 
#42973 - RE: Is it possible through software
Responding to: ???'s previous message
My friend,

If you pay attention to this forum, you should notice that there are less and less reply to your posting, and I think you know the reason.

Whenever you were asked to go back and do some more basic stuffs before start working on your big project, you just refused to do so, and start a new thread.

You should know that every one here are all very willing to help. If you are willing to listen to advise and do things one step a time. You can always come back to ask question of the problems you have.

If you keep on performing as you are now. I don't think anyone will waste time checking the posting from you any more.

Think again and good luck.

Lawrence





List of 9 messages in thread
TopicAuthorDate
Is it possible through software            01/01/70 00:00      
   RE: Is it possible through software            01/01/70 00:00      
   RE: Is it possible through software            01/01/70 00:00      
      Do i need to USe MT8816            01/01/70 00:00      
   RE: Is it possible through software            01/01/70 00:00      
      RE: Is it possible through software            01/01/70 00:00      
         iam doing small projects            01/01/70 00:00      
            Unfortunate misunderstanding            01/01/70 00:00      
               Cut him a little slack            01/01/70 00:00      

Back to Subject List