Me again...! Is sram programmed in the same way as eeproms? I got this info from a site, but it is for eeproms, and i want to know whether i can use the instructions for programming the sram.

a) Set up the address
b) Set up the data needed on the data bus
c) Enable the chip with /CE on pin 20 taken LOW
d) Take the OUTPUT enable HIGH
e) Take the WRITE line on pin 27 LOW for the prescribed time.
f) Select the next address and set up the next byte of data to be written.


Thanks again, gordon.

P.S. Thanks for the address bus info.