| ??? 03/09/04 17:45 Read: times |
#66349 - RE: LPC932 and UART Issue Responding to: ???'s previous message |
Juan Carlos wrote:
Hi, I have a problem when using the LPC932. By Enabling the UART Break Detect Reset through AUXR1 |=0xC0; (also selecting clock low power) the LCP932 does not executed. Does anyone know what could be the problem? 1) The UART break detect will cause a chip reset and force the device into ISP mode. 2) A break is detected when 11 consecutive bits are sensed low. 3) So, if you don't want to have a reset by UART break detect just pull RX pin high. Hope it helps a bit. Regards, George |
| Topic | Author | Date |
| LPC932 and UART Issue | 01/01/70 00:00 | |
| RE: LPC932 and UART Issue | 01/01/70 00:00 | |
| RE: LPC932 and UART Issue | 01/01/70 00:00 | |
| RE: LPC932 and UART Issue | 01/01/70 00:00 | |
| RE: LPC932 and UART Issue | 01/01/70 00:00 | |
| RE: LPC932 and UART Issue | 01/01/70 00:00 | |
RE: LPC932 and UART Issue | 01/01/70 00:00 |