| ??? 12/07/04 09:23 Read: times |
#82688 - complaining Responding to: ???'s previous message |
I dont think you act fair to the people trying to help you, you just give parts of information requested and when you get an answer based on that info, you complain that it is not the answer you want.
YOU wrote: 1. There is a Vcc connected to 40th pin of micro AT89S8252 and GND to 20th pin. 2. RST connected to a switch. On power up I push the switch to reset micro. 3. Four pins of Port1 1.5-1.8 CS, MOSI, MISO, SCK respectively are connected to ST EEPROM M95256 respective pins. 4. There is no other connection to micro. In another post you say that you have crystal and capacitor "But I don't write these kind of basic points." If you just give info that YOU think is needed you get answers based on that information. So YOUR input sets the level of the answers. It might be better to use a supervisor chip for reset. Anders |
| Topic | Author | Date |
| has anybody used SPI | 01/01/70 00:00 | |
| more details please | 01/01/70 00:00 | |
| details | 01/01/70 00:00 | |
| missing code? | 01/01/70 00:00 | |
| How to post code | 01/01/70 00:00 | |
| The story so far? | 01/01/70 00:00 | |
| no solution | 01/01/70 00:00 | |
| all is replied above | 01/01/70 00:00 | |
| So you want a solution? | 01/01/70 00:00 | |
| code and schematic | 01/01/70 00:00 | |
| unconnected reset? | 01/01/70 00:00 | |
| How about some clocking ?? | 01/01/70 00:00 | |
| Code still illegible! | 01/01/70 00:00 | |
| is it C-language? | 01/01/70 00:00 | |
| reply of queries | 01/01/70 00:00 | |
| complaining | 01/01/70 00:00 | |
| Do you want to be helped? | 01/01/70 00:00 | |
| Watch window in Keil | 01/01/70 00:00 | |
Registers window in Keil | 01/01/70 00:00 | |
| EA | 01/01/70 00:00 |