Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
08/01/05 13:39
Read: times


 
#98591 - Something wrong with 74HC165?
Responding to: ???'s previous message
Shivani said:
i tried it with cro,when i ground one input data out never goes low for single during full eightbit read i did not tried by changing chip but before thar i want to be sure about my code.

So, this means that there's something wrong with your 74HC165, but not with the micro?

Kai

List of 28 messages in thread
TopicAuthorDate
74hc165 read problem            01/01/70 00:00      
   pull ps?            01/01/70 00:00      
      external pull up            01/01/70 00:00      
   74LS165 schematic and assembly program            01/01/70 00:00      
      re 74LS165 schematic and assembly progra            01/01/70 00:00      
   connections and timings            01/01/70 00:00      
      Port0 can show very high rise times            01/01/70 00:00      
      thanks oleg and kai            01/01/70 00:00      
      re connections and timings            01/01/70 00:00      
         What pull-ups?            01/01/70 00:00      
            Also....            01/01/70 00:00      
               re also            01/01/70 00:00      
                  Very strange...            01/01/70 00:00      
                     re Very strange...            01/01/70 00:00      
                        Something wrong with 74HC165?            01/01/70 00:00      
                           If you have an oscilloscope..            01/01/70 00:00      
                              re If you have an oscilloscope..            01/01/70 00:00      
            re What pull-ups?            01/01/70 00:00      
               HC vs HCT vs TTL            01/01/70 00:00      
   165 access problem            01/01/70 00:00      
   using opto to pulldown pin of 74hc165            01/01/70 00:00      
      which optocouplers            01/01/70 00:00      
      time for schematics            01/01/70 00:00      
   here is solution            01/01/70 00:00      
   it is working            01/01/70 00:00      
      because of something in your hardware            01/01/70 00:00      
         nop not due to hardware            01/01/70 00:00      
            still could be            01/01/70 00:00      

Back to Subject List