| ??? 08/20/05 09:26 Read: times |
#99719 - Test some things Responding to: ???'s previous message |
I tried to connect the LEDs in parallel and give 3.6V to them with a very small resistor 10Ohm, they will have the acceptable bright, with around 3.8A, around 20mA per LEDs. And the brightness are almost the same.
So check what hapends when you try to do the same in your circuit. May be your souce is smaller for your design or the transistors don't go to saturation...¿? Félix |
| Topic | Author | Date |
| Questionn - Not even brightness for LEDs | 01/01/70 00:00 | |
| Sounds like you've answered the question | 01/01/70 00:00 | |
| What minizium change I need | 01/01/70 00:00 | |
| Test some things | 01/01/70 00:00 | |
| Test | 01/01/70 00:00 | |
| Try PNP instead of NPN | 01/01/70 00:00 | |
| Both method | 01/01/70 00:00 | |
| Increase the voltage accross the load | 01/01/70 00:00 | |
| even brightness... | 01/01/70 00:00 | |
| Spec for LED | 01/01/70 00:00 | |
| something is wrong... | 01/01/70 00:00 | |
| RGB LED's Luminous | 01/01/70 00:00 | |
| even considering voltage will get you in | 01/01/70 00:00 | |
| Explain more | 01/01/70 00:00 | |
| simple, drop the multiplexing | 01/01/70 00:00 | |
| Will this work | 01/01/70 00:00 | |
| Erik says | 01/01/70 00:00 | |
| this will | 01/01/70 00:00 | |
| Can I use UDN2891a | 01/01/70 00:00 | |
| can't say | 01/01/70 00:00 | |
| probably means 2981 | 01/01/70 00:00 | |
if so, you just don't get it do you | 01/01/70 00:00 | |
| why would you do that ? | 01/01/70 00:00 |