| ??? 12/16/05 19:11 Read: times |
#105413 - thanks Responding to: ???'s previous message |
KAI said: "If you have had a look into datasheet of LPC952, then you would have realized, that Shruthi has THOUGHT before putting his question here." Guys it is "her" and not "his"!! Btw my question was simple.... what happens if port pin(P1.1) connected to R2OUT is configured as push-pull? Would it damage the port pin in any manner? Thanks, Shruthi |
| Topic | Author | Date |
| port RX and TX | 01/01/70 00:00 | |
| if you use CodeAtchitect, is that not wh | 01/01/70 00:00 | |
| RXD push pull | 01/01/70 00:00 | |
| it might,. depends on what is connected | 01/01/70 00:00 | |
| Not the reason | 01/01/70 00:00 | |
| He did think | 01/01/70 00:00 | |
| thanks | 01/01/70 00:00 | |
| likely, but not certain, anthow it will | 01/01/70 00:00 | |
| Sorry! | 01/01/70 00:00 | |
| MAX 232 IC | 01/01/70 00:00 | |
| Why push-pull? | 01/01/70 00:00 | |
| It was configured earlier.. | 01/01/70 00:00 | |
| Well done! | 01/01/70 00:00 | |
| Max232 and its 5V | 01/01/70 00:00 | |
| Then only input-only configuration | 01/01/70 00:00 | |
| Thanks!! | 01/01/70 00:00 | |
| Good luck! | 01/01/70 00:00 | |
| Quoting replies | 01/01/70 00:00 | |
thanks | 01/01/70 00:00 |