Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
02/09/06 17:32
Read: times


 		 #109628 - I tend to fix hardware shortcomings with
Responding to: ???'s previous message
So you've never had to cover up other people's hardware shortcomings with software fixes? Must be nice.
I tend to fix hardware shortcomings with wire and software shortcomings with code.

It is fairly easy to glue a DIP chip upside down on a PCB and wire to the legs, it's ugly, but it is cirrecting hardware with hardware. My most common "hardware fix" actually takes place outside the board. right at the connector on the side of the box, unsolder the wire, insert an inductor, solder the wire again.

rik



List of 35 messages in thread
TopicAuthorDate
I2C bit banging            01/01/70 00:00      
   It has I2C bus            01/01/70 00:00      
      question, language and added info            01/01/70 00:00      
         SMB more reliable?            01/01/70 00:00      
            I never hung            01/01/70 00:00      
               Hanging I2C            01/01/70 00:00      
                  No LCD drivers, no hotplug            01/01/70 00:00      
                  Hanging I2C, and freeing it again            01/01/70 00:00      
                     Me too!            01/01/70 00:00      
                        which confirm            01/01/70 00:00      
                           So you've never had to            01/01/70 00:00      
                              I tend to fix hardware shortcomings with            01/01/70 00:00      
                                 Like I said, lucky.            01/01/70 00:00      
                                    doing the impossible            01/01/70 00:00      
                                       Even a nice word for it!            01/01/70 00:00      
                              Look at the philips I2C bus muxes            01/01/70 00:00      
                                 That would make sense            01/01/70 00:00      
            No            01/01/70 00:00      
               For hot plug use SMB            01/01/70 00:00      
               differences SMB IIC            01/01/70 00:00      
   I2C with hang recovery            01/01/70 00:00      
    I2C bit banging: yes !            01/01/70 00:00      
      I see nobody "fighting"            01/01/70 00:00      
         Re Erik            01/01/70 00:00      
            WHO, in his/her right mind would use pol            01/01/70 00:00      
               Really ?            01/01/70 00:00      
                  never used the 552            01/01/70 00:00      
                     HW-I2C not identical !            01/01/70 00:00      
                        where did you gtet that impression?            01/01/70 00:00      
                           Nice            01/01/70 00:00      
                           Re: SW-I2C efficiency            01/01/70 00:00      
                              then the question is "when"            01/01/70 00:00      
                                 No illnes seen until today            01/01/70 00:00      
                                    well, I can't            01/01/70 00:00      
            Good point            01/01/70 00:00      

Back to Subject List