Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
10/17/06 13:33
Read: times


 
#126570 - x = C , pardon for using short form
Responding to: ???'s previous message
It is 24c64 by atmel . I sent hi address FF and Low address FF and wrote a byte there it it got written ,but when i incremented address further it rolled back starting location. doesnt the 64kilobit chip has locations till 8000decimal or 1F40hex ?.

AP

List of 24 messages in thread
TopicAuthorDate
64K electrical-erasable-prom addressing            01/01/70 00:00      
   there is NO SUCH THING as "AN" 24x64 eeprom. All            01/01/70 00:00      
      x = C , pardon for using short form            01/01/70 00:00      
         double post, ignore            01/01/70 00:00      
         where did you get that number?            01/01/70 00:00      
            524280bits of space            01/01/70 00:00      
               look at this            01/01/70 00:00      
            'k' vs 'K'            01/01/70 00:00      
               Contradiction            01/01/70 00:00      
                  I give up            01/01/70 00:00      
                  me too            01/01/70 00:00      
                     OK cardboard did not work, let's try bending it in            01/01/70 00:00      
                        OK cardboard did not work, let's try bending it in            01/01/70 00:00      
                           Cardboard            01/01/70 00:00      
                     More basic arithmetic            01/01/70 00:00      
                        On atmel datasheet page 8            01/01/70 00:00      
                           Think about it...            01/01/70 00:00      
                           put this away, go get some sleep            01/01/70 00:00      
                  It's basic arithmetic!            01/01/70 00:00      
   Have you read the datasheet?            01/01/70 00:00      
      See diagram            01/01/70 00:00      
   Lookup table or what ?            01/01/70 00:00      
      2 suggestions            01/01/70 00:00      
      Review questions            01/01/70 00:00      

Back to Subject List