Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
07/31/01 18:16
Read: times


 
#13701 - RE: my program not work properly
Hi.
Signal isolation should be done. Keep away from ignition coil. Use C decoupling 0.1uF put near MCU . Be careful GND loop.


List of 14 messages in thread
TopicAuthorDate
my program not work properly            01/01/70 00:00      
RE: my program not work properly            01/01/70 00:00      
RE: my program not work properly            01/01/70 00:00      
RE: my program not work properly            01/01/70 00:00      
RE: my program not work properly            01/01/70 00:00      
RE: my program not work properly            01/01/70 00:00      
RE: my program not work properly            01/01/70 00:00      
RE: my program not work properly            01/01/70 00:00      
RE: my program not work properly            01/01/70 00:00      
Suggestions on detecting the signal.            01/01/70 00:00      
RE: Suggestions on detecting the signal.            01/01/70 00:00      
RE: Suggestions on detecting the signal.            01/01/70 00:00      
RE: my program not work properly            01/01/70 00:00      
RE: my program not work properly            01/01/70 00:00      

Back to Subject List