hi
i done the project on "sending email from microcontroller" in this project i used the microcontroller as to monitor a simple motor.if the speed of motor is automatically go above my limit(critical speed i set),it automatically mail to company supervisor
1 first i measure the speed of motor by sensor,a nd then i compare the speed with predetermined speed if speed increses the certain value then microcontroller is send the signal through serial port and modem and through that telephone cable.
to send the mail(i wrote the code in c)
1. i initialize the serial port. and also intialize the tcp/ip and smtp.
2.whenever the speed increases the limit, the data in the serial port is automatically transfer through telephone cable.to i specified email address




if you want any other clrification then again post the doubt