| ??? 05/12/08 08:40 Read: times |
#154699 - hyperterminal setting Responding to: ???'s previous message |
Hi
I always using hyperterminal when I make micro program for communicate with PC, so far no problem. Just set which COM that connected to PC, set start and stop bit and data length, set baud rate that match with micro setting. Then coonected...If your micro program is correct just type any key fro hyperterminal and the micro will reply back... But last time I have similar problem...My micro can send to hyperterminal..but can not receive data from the PC...After check everything i found that it is hardware problem..DB9 connector not match... |
| Topic | Author | Date |
| Serial communication problem with AT89S52 | 01/01/70 00:00 | |
| hyperterminal setting | 01/01/70 00:00 | |
| As I said | 01/01/70 00:00 | |
| FAQ | 01/01/70 00:00 | |
| try this | 01/01/70 00:00 | |
| Flow Control | 01/01/70 00:00 | |
| Yes, but | 01/01/70 00:00 | |
| Try this | 01/01/70 00:00 | |
| So? | 01/01/70 00:00 | |
| Cool!! And it worked!!! | 01/01/70 00:00 | |
| how did it work | 01/01/70 00:00 | |
What I meant was | 01/01/70 00:00 |