| ??? 07/22/08 06:21 Read: times |
#156925 - Isolation Responding to: ???'s previous message |
For motor control I prefer to use opto coupler to isolate driver chip from microcontroller because there is a good chance that the motor driver would get short circuited and a high voltage would destroy your microcontroller.
Otherwise a use of buffer is used so that in case of emergency the buffer will be blown and you save the microcontroller. Mahmood |
| Topic | Author | Date |
| Stepper motor drive with 8051 | 01/01/70 00:00 | |
| my 'general rule' is | 01/01/70 00:00 | |
| General rule? | 01/01/70 00:00 | |
| direct if on-board, buffer if not | 01/01/70 00:00 | |
| not in more words | 01/01/70 00:00 | |
| More words | 01/01/70 00:00 | |
| Isolation | 01/01/70 00:00 | |
this MAY be relevant | 01/01/70 00:00 |