Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
08/05/11 11:42
Modified:
  08/05/11 12:21
Read: times


 		 #183214 - working at 1200 baud
Responding to: ???'s previous message
i finally got it working at 1200baud there were 2 mistakes one with
din = din >> 1
and the other with the no of iterations
ill try it upto 4800baud and reply again if i have any trouble
any suggestions about the code posted above would be helpful
EDIT: transmitting and receiving at 4800 baud successfully at 11.059200MHz clock

List of 30 messages in thread
TopicAuthorDate
bit banging program touble            01/01/70 00:00      
   why?            01/01/70 00:00      
      i need a second serial port            01/01/70 00:00      
         something like this , without any warranty :            01/01/70 00:00      
         a good start would be ...            01/01/70 00:00      
            only 3 'U's are commingout of 100            01/01/70 00:00      
               Separate the characters and look with scope            01/01/70 00:00      
                  finally it worked            01/01/70 00:00      
                     uart receiver in software            01/01/70 00:00      
   No I/O or No Timing            01/01/70 00:00      
      "No I/O or No Timing"            01/01/70 00:00      
   Someday you will learn...            01/01/70 00:00      
      this isnt the actual code            01/01/70 00:00      
         Well then another lesson to learn...            01/01/70 00:00      
   Assembler Manual will help you            01/01/70 00:00      
      assembler manual?            01/01/70 00:00      
   Data is 8 Bit??            01/01/70 00:00      
   Bit width timing and timer TH0,TL0 Values            01/01/70 00:00      
      checked values for TH0 and TL0            01/01/70 00:00      
         keil baud rate Calculator not for bit bang            01/01/70 00:00      
   LSB first            01/01/70 00:00      
   now reception....            01/01/70 00:00      
      1) din = din >> 1            01/01/70 00:00      
         working at 1200 baud            01/01/70 00:00      
            delayRS()            01/01/70 00:00      
               why do i have to sample stop bit            01/01/70 00:00      
                  Need not, but should            01/01/70 00:00      
                  because            01/01/70 00:00      
                     Much to a real UART            01/01/70 00:00      
                  1.5 bit delay            01/01/70 00:00      

Back to Subject List