Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
10/09/12 13:40
Read: times


 		 #188610 - price/performance
Responding to: ???'s previous message
f you want to replace an expensive part with a cheaper one, typically, you have to accept some "spec degradation".

can your replacement be e.g. slower, have a bit more max error, ....

maybe, MAYBE, you can answer the above by posting the application.

Erik

List of 27 messages in thread
TopicAuthorDate
About AD574A            01/01/70 00:00      
   suitable            01/01/70 00:00      
   price/performance            01/01/70 00:00      
      Expensive or old            01/01/70 00:00      
         if it's not "obsolete" it probably should be            01/01/70 00:00      
            It's not obsolete            01/01/70 00:00      
               I wonder what's keeping it "alive"            01/01/70 00:00      
                  It became an industry standard...            01/01/70 00:00      
                     LM358            01/01/70 00:00      
                        Dated            01/01/70 00:00      
   'Find Similar Parts'            01/01/70 00:00      
      I did not find any matching IC            01/01/70 00:00      
         Be Happy            01/01/70 00:00      
            Ok so,            01/01/70 00:00      
               No, that's not what it means!            01/01/70 00:00      
         RE: None of them match the Pin structure            01/01/70 00:00      
   Maxim?            01/01/70 00:00      
      I might be just a bit concerned about the conversion rate            01/01/70 00:00      
   if it is repair, who cares            01/01/70 00:00      
      There are places where that's a week's pay            01/01/70 00:00      
         sure ...            01/01/70 00:00      
            What was the goal?            01/01/70 00:00      
            just a minute ..            01/01/70 00:00      
   Ok ... so here is what i would do            01/01/70 00:00      
      then why the worry about the pinout ?            01/01/70 00:00      
         Thanks Guys            01/01/70 00:00      
            you probably should back away from the original            01/01/70 00:00      

Back to Subject List