Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
12/03/12 13:15
Read: times


 		 #188952 - Vdd ramp time
Responding to: ???'s previous message
Unfortunately not in the datasheet of the old C8051F230, but the datasheet for the (slightly younger) C8051F300 clearly states:
C8051F30x.pdf said:
The maximum VDD ramp time is 1 ms; slower ramp times may cause the device to be
released from reset before VDD reaches the VRST level.

Furthermore, I very much doubt that the 8051 core in a SiLabs part resembles the original intel design. What Richard observed during active reset in other devices may not apply for these ones.

Maarten

List of 33 messages in thread
TopicAuthorDate
C8051F231 experiences            01/01/70 00:00      
   another solution            01/01/70 00:00      
   The probabilities are low...            01/01/70 00:00      
      think about what happens when you add a finger            01/01/70 00:00      
         The point is ...            01/01/70 00:00      
            Yes ... the underlying issue is the flash ...             01/01/70 00:00      
               Out of my office, but...            01/01/70 00:00      
                  Don't think in Vcc, ESD or hum...            01/01/70 00:00      
   Apparently several C8051F2xx parts have the same pinout            01/01/70 00:00      
   Characteristic for in system programmable flash micros...            01/01/70 00:00      
      All too true ... sadly ...             01/01/70 00:00      
         Power-on slope rate...            01/01/70 00:00      
            Sorry, my post should be here, no up there...            01/01/70 00:00      
            Have you any basis for that rate?            01/01/70 00:00      
               Vdd ramp time            01/01/70 00:00      
               Some datasheets show numbers...            01/01/70 00:00      
                  Those aren't the "usual" 805x-core MCU's            01/01/70 00:00      
                     There aren't many "usual" 8051-cores anymore...            01/01/70 00:00      
                        How dangerous power ups can be...            01/01/70 00:00      
                           I believe it            01/01/70 00:00      
                              (dV/dt) examples            01/01/70 00:00      
                                 They don't know it either...            01/01/70 00:00      
                                    dV/dT etc             01/01/70 00:00      
                                       reset request...            01/01/70 00:00      
                                          That's what disturbs me greatly            01/01/70 00:00      
                                             It IS disturbing!            01/01/70 00:00      
                                                Where this began ... at least for me ...             01/01/70 00:00      
                                                   So, you took the hard road...            01/01/70 00:00      
                                                      We've all had that experience             01/01/70 00:00      
   probable cause            01/01/70 00:00      
      Brent, this is very nice            01/01/70 00:00      
         forum no longer down            01/01/70 00:00      
      Thank you!            01/01/70 00:00      

Back to Subject List