Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
09/06/02 11:29
Read: times


 		 #28724 - RE: Fail to initialise LCD using 4 bit mode
I have experienced problems with LCDs:
The busy signal should be checked AFTER you send a set of bits.

It's ironic !!! write than check if busy and not release it until isn't.

I hope it will help you.



Eddy.


You can find me at : care2much@k.ro

or wwaco.go.ro

List of 15 messages in thread
TopicAuthorDate
Fail to initialise LCD using 4 bit mode            01/01/70 00:00      
RE: Fail to initialise LCD using 4 bit mode            01/01/70 00:00      
RE: Fail to initialise LCD using 4 bit mode            01/01/70 00:00      
RE: Fail to initialise LCD using 4 bit mode            01/01/70 00:00      
RE: Fail to initialise LCD using 4 bit mode            01/01/70 00:00      
RE: Problem in tutorial!            01/01/70 00:00      
RE: Problem in tutorial!            01/01/70 00:00      
RE: Problem in tutorial!            01/01/70 00:00      
RE: Problem in tutorial!            01/01/70 00:00      
RE: Fail to initialise LCD using 4 bit mode            01/01/70 00:00      
RE: Fail to initialise LCD using 4 bit m            01/01/70 00:00      
RE: Fail to initialise LCD using 4 bit mode            01/01/70 00:00      
RE: Fail to initialise LCD using 4 bit mode            01/01/70 00:00      
RE: Fail to initialise LCD using 4 bit mode            01/01/70 00:00      
RE: Fail to initialise LCD using 4 bit mode            01/01/70 00:00      

Back to Subject List