| ??? 10/16/02 05:31 Read: times |
#30865 - RE: Thermal resistance |
<html>This is a good question for embedded systems specially in small enclosures where you need to stuff many electronics. The most important factor in thermal resistance or (on the other hand) thermal conductivity of your case is the material its made of and the flow of air. Plastics are bad in this regard as they don't conduct heat well.
You need to fill in all the elctronics and than add the sensor hanging in air and measure the temperature atleast after 5 min of operation or may be you can take many readings and average them and take the measurement otuside the case without touching the walls of the case. Also 1 more factor you need to consider is the temperature in the room or place itself where the case is fitted/mounted etc. Hope this could be some help. Good Luck IS</html> |
| Topic | Author | Date |
| Thermal resistance | 01/01/70 00:00 | |
| RE: Thermal resistance | 01/01/70 00:00 | |
| RE: Thermal resistance, Steve | 01/01/70 00:00 | |
| RE: Thermal resistance | 01/01/70 00:00 | |
| RE: Thermal resistance, Steve | 01/01/70 00:00 | |
| RE: Thermal resistance | 01/01/70 00:00 | |
| RE: Thermal resistance | 01/01/70 00:00 | |
| RE: Thermal resistance? Where 8051 part? | 01/01/70 00:00 | |
| RE: Thermal resistance, Charles | 01/01/70 00:00 | |
| RE: Thermal resistance, Steve | 01/01/70 00:00 | |
| RE: //Charles | 01/01/70 00:00 | |
| RE: //Charles | 01/01/70 00:00 | |
| RE: //Charles | 01/01/70 00:00 | |
| RE: Thermal resistance | 01/01/70 00:00 | |
RE: //Steve/Charles | 01/01/70 00:00 |