Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
11/07/02 13:14
Read: times


 		 #32123 - RE: INT1 doesn\\\'t go low
Test procedure:
"Connect a 470 ohm resistor between P3.3 and ground. If the voltage is still 2.3 V, your uC is probably damaged."

Test results:
Done. Voltage stays at 2.3.

Conclusion:
Then the uC is probably damaged.

Maybe you should want to repeat the test with a minimal SW running (say a jmp $ instruction at zero address). This way you will avoid any SW side effects.

Alfredo.


List of 8 messages in thread
TopicAuthorDate
INT1 doesn\'t go low            01/01/70 00:00      
RE: INT1 doesn\'t go low            01/01/70 00:00      
RE: INT1 doesn\\\'t go low            01/01/70 00:00      
RE: INT1 doesn\'t go low            01/01/70 00:00      
RE: INT1 doesn\'t go low            01/01/70 00:00      
RE: INT1 doesn\\\'t go low            01/01/70 00:00      
RE: INT1 doesn\\\'t go low            01/01/70 00:00      
RE: INT1 doesn\\\'t go low            01/01/70 00:00      

Back to Subject List