Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
11/13/02 19:49
Read: times


 		 #32427 - RE: Shaft Encoder Noise Problem
The list Steve refer to is here
the micro is operating at 3.3v
you get better noise immunity with a 5V uC

Is your opto isolation truly opto-isolated i.e. can you ground either wire without any bad effect?. If not, you are NOT opto-isolated, just "using opto-isolators".

Erik

List of 14 messages in thread
TopicAuthorDate
Shaft Encoder Noise Problem            01/01/70 00:00      
RE: Shaft Encoder Noise Problem            01/01/70 00:00      
RE: Shaft Encoder Noise Problem            01/01/70 00:00      
RE: Shaft Encoder Noise Problem            01/01/70 00:00      
RE: Shaft Encoder Noise Problem            01/01/70 00:00      
RE: Shaft Encoder Noise Problem            01/01/70 00:00      
RE: Shaft Encoder Noise Problem            01/01/70 00:00      
RE: Shaft Encoder Noise Problem            01/01/70 00:00      
RE: Shaft Encoder Noise Problem clearer            01/01/70 00:00      
RE: Shaft Encoder Noise Problem            01/01/70 00:00      
RE: Shaft Encoder Noise another way            01/01/70 00:00      
RE: Shaft Encoder Noise another way            01/01/70 00:00      
RE: Shaft Encoder Noise another way            01/01/70 00:00      
RE: Shaft Encoder Noise another way            01/01/70 00:00      

Back to Subject List