Hi all,

I am working with serial port(uart) mode 0 . In mode 0 my chip manual it was said in a note " At both low and high speed in Mode 0(Synchronous mode), data on RXD0 is sampled two CLKOUT cycles before the rising clock edge on TXD0."
RXD0 ------ recieving end
TXD0 ------ recieving clock

because of RXD0 is sampled two clkout cycles before the rising clock edge on TXD0 , the recieving data is always wrong value in synchronous mode 0.

Is there any way RXD0 sampled synchronously with TXD0, so that I can recieve correct data .

if it is a case as explained in the note, data recieved by RXD0 will always be wrong value. because RXD0 is not sampled with synchronously with TXD0.

please help me out of this problem

best regards
madhu



PS: cheers to historic win of india against pakistan in pakistan