Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
02/10/05 18:10
Read: times


 
#87098 - Alu foil, asbestos shield
Responding to: ???'s previous message
Prahlad said:
I changed the resistor R to 47k and the Ra to 10K and with this setup I could see a change in integrator output.

Did you see true inverse proportionality? If not, then there's somewhere an error. Try to properly display the spikes from Rogowski coil by a good storage scope. Choose R + Ra in such a way, that no more than about 1mA is flowing. Otherwise the output of OPamp will be overdriven. Unfortunately such an overdrive condition cannot directly be seen, when observing the output of integrator, because the spike is captured in the integration capacitance. So, an overdrive condition refering to output current capability can only be noticed, by checking the output voltage of Rogowski coil and refering this to integration resistance (R + Ra).

Can I use aluminium foil for shielding purpose or something else?

Yes, even very thin alu foil is sufficient.

Apart from this electrical shield I will also be using Asbestos shield for protecting coil from welding spark and heat.

Please be very careful with this asbestos shield!!! Do not produce asbestos dust, do not inhale it!!! Could you use an alternative?

Please, be very careful!
Kai


List of 21 messages in thread
TopicAuthorDate
My Rogowski Coils            01/01/70 00:00      
   If it ain't broke            01/01/70 00:00      
      Lack of confidence.            01/01/70 00:00      
         Art of electronics            01/01/70 00:00      
            No I haven't.            01/01/70 00:00      
         OP AMP basic definitions            01/01/70 00:00      
   Kai- Please Check your mailbox.            01/01/70 00:00      
   Three things that scare me.            01/01/70 00:00      
   More concrete schematic            01/01/70 00:00      
      Re: Concrete Schematic.            01/01/70 00:00      
         Rogowski coil            01/01/70 00:00      
      Did I Miss Something -Kai.            01/01/70 00:00      
         You should see a change!            01/01/70 00:00      
            Yes I could see the change Thanks.            01/01/70 00:00      
               Alu foil, asbestos shield            01/01/70 00:00      
                  Asbestos            01/01/70 00:00      
                     There's no 'corner frequency'            01/01/70 00:00      
   Integrating Capacitor. -Kai            01/01/70 00:00      
      MKP, select for low offset            01/01/70 00:00      
         How about these.            01/01/70 00:00      
            Are ok            01/01/70 00:00      

Back to Subject List