| ??? 07/13/08 08:33 Read: times |
#156662 - Solution for capsense board design considerations |
Hi,
Iam designing PCB which has capsense. I am using Orcad16- PCB Editor. I am facing problem in putting copper pour (Hatched and full) around capsense and also on how the each copper pour (Hatched and full) could be connected to a corresponding pin in PSoc controller. The figure below shows the way i need to implement: 
Could any one tell me how to achieve this in Orcad 16. Thanking You. Suresh. |
| Topic | Author | Date |
| Solution for capsense board design considerations | 01/01/70 00:00 | |
| Did you try at Cadence? | 01/01/70 00:00 | |
| I have cross posted in Orcad forum.. | 01/01/70 00:00 | |
| Z-orders in Orcad... | 01/01/70 00:00 | |
| obsticle? | 01/01/70 00:00 | |
| I mean "obstacle" | 01/01/70 00:00 | |
| Thats what i need to do.. | 01/01/70 00:00 | |
| Unfortunately, I cannot help... | 01/01/70 00:00 | |
| Alternatively... | 01/01/70 00:00 | |
| Ok. Thanks for your replies! | 01/01/70 00:00 | |
| Good News... | 01/01/70 00:00 | |
| iam in midway to succeed | 01/01/70 00:00 | |
| Well, I installed version 16.0 and... | 01/01/70 00:00 | |
i got that right yesterday | 01/01/70 00:00 |