| ??? 08/25/05 09:53 Read: times |
#100056 - more detailed definition Responding to: ???'s previous message |
ok i have a board with the 8052AH Basic. i had it conected to my pc and just played a little bit arround with some small progamms on the 8052. then i resetet it and since this moment i cann't do anything on it. it boots up but then every command i send returns an error. i have the same VCC and i didn't chancged any wirings. i have also 4 different RAM ICs and i checked with each of them and the same result :-( any ideas?
ps: is there a general restore to default command for the 8052? p.e. if i program the 8052 to save the baud settings when will it be reseted? when i disconnect power? thanks richard |
| Topic | Author | Date |
| "Software" problem with 8052 basic | 01/01/70 00:00 | |
| Bad RAM | 01/01/70 00:00 | |
| HW? | 01/01/70 00:00 | |
| Oops. | 01/01/70 00:00 | |
| more detailed definition | 01/01/70 00:00 | |
| no nonovolatile memory in 8052 | 01/01/70 00:00 | |
| hey jan | 01/01/70 00:00 | |
| Am I missing something ? | 01/01/70 00:00 | |
| circuit | 01/01/70 00:00 | |
| I do not know anythong about BASIC but w | 01/01/70 00:00 | |
| in fact, there is no EPROM... | 01/01/70 00:00 | |
Burning circuit ? | 01/01/70 00:00 |