I need help using the SPI of LPC936. I used code architect and set the respective ports for I/O respectively. When I execute the code I do not see any response on the SPI pins. I am using scope to check this. Here is my set up.

SPCTL = 0xD7;// configure SPI
ESPI = 1;    // enable SPI interrupt

// send a byte
  Chip_S = 1; // slave select  
  SPDAT = 0x09;          // Send byte command 
  delay();
  SPDAT = 0x80;	 	 // send address byte 
  delay();
  Chip_S = 0;   // end trans to slave

if I execute the code above, shouldn't I be seeing something in the SPI pins through the scope? I am using the internal clock at 7.37MHz.
Thanks