| ??? 05/11/07 07:00 Modified: 05/11/07 07:01 Read: times |
#139031 - Answers Responding to: ???'s previous message |
Andrew Ayre said:
If you can reprogram the device after cycling the power to the board, then it is still configured to use the internal RC oscillator.
Read the status bit and check it is cleared (ISP -> Read Boot Vector and Status Bit...) Did you move the jumper from the Reset position to the Run position? Does the Keil Blinky example still work? Andy Hi Andy, Thanks for looking. Status bit is cleared. Jumper set to run. Blinky still works fine. No luck still though... I think I'm going to try just turning P2.0 on. Not sure I can get any more trivial than that! |
| Topic | Author | Date |
| lpc935 and mcb900. Am I missing something? | 01/01/70 00:00 | |
| put the MACRO at the top | 01/01/70 00:00 | |
| Thanks... | 01/01/70 00:00 | |
| where is it going to come from | 01/01/70 00:00 | |
| How can I check? | 01/01/70 00:00 | |
| Does flashmagic have a buffer? | 01/01/70 00:00 | |
| is the oscillator running (enable clkout and scope | 01/01/70 00:00 | |
| Thanks guys. | 01/01/70 00:00 | |
| LPC9xx | 01/01/70 00:00 | |
| Answers | 01/01/70 00:00 | |
| Ah. Input only. | 01/01/70 00:00 | |
| LPC900 - A differnet animal | 01/01/70 00:00 | |
| Thanks Joe. | 01/01/70 00:00 | |
| UCFG1 | 01/01/70 00:00 | |
| Code Architect | 01/01/70 00:00 | |
Thanks again | 01/01/70 00:00 |