Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
08/13/07 15:13
Read: times


 		 #143172 - and what?
Responding to: ???'s previous message
Why should I look up what the heck that eval board is?

And, even then, how can I know he did not use some sort of socket conversion?

And, most of all, it was suspicious that he mentioned "pin 20 hooked to ground", I didn't think this is worth mentioning if this is the GND pin...


JW


List of 33 messages in thread
TopicAuthorDate
blinking LED won't blink            01/01/70 00:00      
   Describe The Connection            01/01/70 00:00      
      show your schematic            01/01/70 00:00      
         how true            01/01/70 00:00      
   it IS blinking, but you don\'t see it it\'s too fast            01/01/70 00:00      
      You're right, Jan! It is a 16,384 MHz one-clocker            01/01/70 00:00      
   before Andy or Erik runs on you...            01/01/70 00:00      
      40pin PDIP, he mentioned the eval board...            01/01/70 00:00      
         and what?            01/01/70 00:00      
            Very suspicious            01/01/70 00:00      
               Ignore him            01/01/70 00:00      
                  But then he learns nothing            01/01/70 00:00      
                     Valid point! It's about documentation!            01/01/70 00:00      
                  .. or ask for additional info...            01/01/70 00:00      
               Does anybody see a "proper" reset?            01/01/70 00:00      
         and so what?            01/01/70 00:00      
            He\'s being optimistic            01/01/70 00:00      
               18 messages so far.            01/01/70 00:00      
   Are you using the on-board LED\'s?            01/01/70 00:00      
      How many people do we need            01/01/70 00:00      
         just two:            01/01/70 00:00      
            zero            01/01/70 00:00      
         You forgot YOUR contribution to the list...            01/01/70 00:00      
   blinking LED wont blionk with schematics            01/01/70 00:00      
      Sink instead of source            01/01/70 00:00      
         mov r1,#255h?            01/01/70 00:00      
            OP used "#255h". Knows the hell...            01/01/70 00:00      
         this will be a little bit too slow            01/01/70 00:00      
            What would be a nice blinking period??            01/01/70 00:00      
               OK, OK....            01/01/70 00:00      
                  I also had a long day...            01/01/70 00:00      
    Reply:blinking LED won't blink            01/01/70 00:00      
      No need            01/01/70 00:00      

Back to Subject List