Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
08/17/07 12:13
Read: times


 		 #143372 - No need
Responding to: ???'s previous message
As it was stated several times in this forum, ports are input AND output. In some part of the code, Salim put CPL P1.0
This instruction toggles the pin state, without any other previous initialisation.
Daniel

List of 33 messages in thread
TopicAuthorDate
blinking LED won't blink            01/01/70 00:00      
   Describe The Connection            01/01/70 00:00      
      show your schematic            01/01/70 00:00      
         how true            01/01/70 00:00      
   it IS blinking, but you don\'t see it it\'s too fast            01/01/70 00:00      
      You're right, Jan! It is a 16,384 MHz one-clocker            01/01/70 00:00      
   before Andy or Erik runs on you...            01/01/70 00:00      
      40pin PDIP, he mentioned the eval board...            01/01/70 00:00      
         and what?            01/01/70 00:00      
            Very suspicious            01/01/70 00:00      
               Ignore him            01/01/70 00:00      
                  But then he learns nothing            01/01/70 00:00      
                     Valid point! It's about documentation!            01/01/70 00:00      
                  .. or ask for additional info...            01/01/70 00:00      
               Does anybody see a "proper" reset?            01/01/70 00:00      
         and so what?            01/01/70 00:00      
            He\'s being optimistic            01/01/70 00:00      
               18 messages so far.            01/01/70 00:00      
   Are you using the on-board LED\'s?            01/01/70 00:00      
      How many people do we need            01/01/70 00:00      
         just two:            01/01/70 00:00      
            zero            01/01/70 00:00      
         You forgot YOUR contribution to the list...            01/01/70 00:00      
   blinking LED wont blionk with schematics            01/01/70 00:00      
      Sink instead of source            01/01/70 00:00      
         mov r1,#255h?            01/01/70 00:00      
            OP used "#255h". Knows the hell...            01/01/70 00:00      
         this will be a little bit too slow            01/01/70 00:00      
            What would be a nice blinking period??            01/01/70 00:00      
               OK, OK....            01/01/70 00:00      
                  I also had a long day...            01/01/70 00:00      
    Reply:blinking LED won't blink            01/01/70 00:00      
      No need            01/01/70 00:00      

Back to Subject List