| ??? 09/12/07 13:53 Read: times |
#144459 - DPM are normally very highohmic ... Responding to: ???'s previous message |
... at the input to ease the use. If there are protection diodes mounted on them, then normally the associated leakage currents are irrelevant. Hardly the cause of observed "non-linearity".
Maybe we shouldn't take Jprao's comment too literally? Maybe he only means, that due to the finite input impedance of DPM, which he hasn't considered in his calculation up to now, the actual division factor is far away from 1000M/1M?? Kai |
| Topic | Author | Date |
| High Voltage measurement | 01/01/70 00:00 | |
| reply | 01/01/70 00:00 | |
| Proper reading? | 01/01/70 00:00 | |
| non linear | 01/01/70 00:00 | |
| Resistor divider rating | 01/01/70 00:00 | |
| NON-linear ??? | 01/01/70 00:00 | |
| what is 'across' the 1M | 01/01/70 00:00 | |
| Does it matter | 01/01/70 00:00 | |
| e.g. A \'protection diode\' may leak a bit | 01/01/70 00:00 | |
| Parasitic ? | 01/01/70 00:00 | |
| DPM are normally very highohmic ... | 01/01/70 00:00 | |
| the problems | 01/01/70 00:00 | |
| A good idea, indeed! | 01/01/70 00:00 | |
| DPM input | 01/01/70 00:00 | |
| Thanks to all | 01/01/70 00:00 | |
| That's all very well | 01/01/70 00:00 | |
| Yes, Jprao, please answer our questions! | 01/01/70 00:00 | |
| DIffierent Divider Perhaps | 01/01/70 00:00 | |
| DPM? | 01/01/70 00:00 | |
| DPM is a widely used term... | 01/01/70 00:00 | |
| many DPMs use ICL7106 | 01/01/70 00:00 | |
Yes, evolves into a heart-stopping thread... | 01/01/70 00:00 |