Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
12/14/07 14:33
Read: times


 		 #148216 - about 1 meter!
Responding to: ???'s previous message
Ap Charles said:

Your above schematic shows no isolation between TX and RX lines what ever you transmit will be sensed back by the CPLD , You need some type of switch to isolate the RX line when you transmit.

Thanks,there is some handshaking signals between mcu and cpld for what you have mentioned.




List of 56 messages in thread
TopicAuthorDate
I/O Electrical Specification            01/01/70 00:00      
   have a look at J1708            01/01/70 00:00      
      J1708 INTERFACE CIRCUIT            01/01/70 00:00      
         naah            01/01/70 00:00      
   an I/O compatibility.            01/01/70 00:00      
      an I/O compatibility            01/01/70 00:00      
   fet+resistor for TX, resistor + comparator RX            01/01/70 00:00      
      more clarification!            01/01/70 00:00      
         What is the effective communication distance            01/01/70 00:00      
            about 1 meter!            01/01/70 00:00      
               NO, that would be wrong if multimaster            01/01/70 00:00      
                  master and slave            01/01/70 00:00      
                  But we already know what we are Transmitting            01/01/70 00:00      
         more clarification needed            01/01/70 00:00      
            more clarification needed            01/01/70 00:00      
      J1708 Problems            01/01/70 00:00      
         Confusing A-line and B-line in a plug?            01/01/70 00:00      
         90% of J1708 devices            01/01/70 00:00      
   Please tell us which chip you use!            01/01/70 00:00      
      i must simulate ECU behavior,not a single chip            01/01/70 00:00      
         what is the bit rate and will this do            01/01/70 00:00      
            5 bps!            01/01/70 00:00      
               it will make the output 110 ohms            01/01/70 00:00      
                  a positive to you erik.            01/01/70 00:00      
                  DG211?            01/01/70 00:00      
                     you need an analog switch            01/01/70 00:00      
                        4066 /DG211?            01/01/70 00:00      
                           Use an analog Multiplexer instead eg ADG509A            01/01/70 00:00      
   Final Scheme,Any Advice?            01/01/70 00:00      
      some            01/01/70 00:00      
         A positive to you Stefan,            01/01/70 00:00      
         IRF7303            01/01/70 00:00      
         SW1            01/01/70 00:00      
      Link and circuit...            01/01/70 00:00      
         3 Positive to you Kai,            01/01/70 00:00      
         what happens on RX when in+>in-            01/01/70 00:00      
            LM393 is comparator with open collector output            01/01/70 00:00      
               Ok,            01/01/70 00:00      
         some question!            01/01/70 00:00      
            Answers            01/01/70 00:00      
               Tahnks Kai for you valuable time,            01/01/70 00:00      
         thanks again but            01/01/70 00:00      
            No, isnt needed            01/01/70 00:00      
               Thanks            01/01/70 00:00      
               Thanks            01/01/70 00:00      
         Link and circuit...            01/01/70 00:00      
             Link and circuit            01/01/70 00:00      
            Please read "Functional Description" of datasheet            01/01/70 00:00      
               Mehdi why you want to invent the wheel??            01/01/70 00:00      
                  Mehdi why you want to invent the wheel??            01/01/70 00:00      
   no offense, but I think you are off the rocker            01/01/70 00:00      
      lower depth of knoledghe            01/01/70 00:00      
      Its known as progressive evolution            01/01/70 00:00      
      So, you blindly guessed...            01/01/70 00:00      
         what is an ECU?            01/01/70 00:00      
            Engine Control Unit            01/01/70 00:00      

Back to Subject List