| ??? 12/26/07 13:58 Read: times |
#148708 - Low state current Responding to: ???'s previous message |
Hi John,
RLP434 output low current (sink) is 10uA (according to datasheet). To keep P3.0 low you need more than that (50/70uA in 80C51). I suggest the use of some CMOS buffer (any AND or OR gate can make it) between RLP434 output and P3.0. Good luck! Daniel |
| Topic | Author | Date |
| 8051 Port Pin wont go low | 01/01/70 00:00 | |
| Try this | 01/01/70 00:00 | |
| here is the schematic | 01/01/70 00:00 | |
| RC-reset is wrong! | 01/01/70 00:00 | |
| That RST schematic is for AVR , which | 01/01/70 00:00 | |
| yes schematic shows wrong reset | 01/01/70 00:00 | |
| Low state current | 01/01/70 00:00 | |
| I tried this | 01/01/70 00:00 | |
| You should use CMOS | 01/01/70 00:00 | |
| here is the code | 01/01/70 00:00 | |
| signal source is inadequate, code is irrelevant | 01/01/70 00:00 | |
| The 7407 has the same problem ... | 01/01/70 00:00 | |
| would this work? | 01/01/70 00:00 | |
| why not 'H' why 'HC"? | 01/01/70 00:00 | |
| its what I have | 01/01/70 00:00 | |
| H ??? Didn\'t they quit making that in the \'70s? | 01/01/70 00:00 | |
| 74HC04 is working | 01/01/70 00:00 | |
Single transistor | 01/01/70 00:00 | |
| these superfluous facts in the datasheet | 01/01/70 00:00 |