| ??? 02/03/09 08:21 Read: times |
#161976 - Frequency Multiplier Responding to: ???'s previous message |
Dear Sir,
It is not possible to acceess Motor1 or it's related hardware I am just getting Encoder Pules and Using these Encoder Pulses i have to drive Motor2. The Frequency multiplication factor is either Settble using DIP Switch.which is constant throug out rocess. One Way I found is the way is that adjust the Encoder PPR but desir PPR encoder may not be aviable in the Market and it is not Suatable Soluation. regards satish |
| Topic | Author | Date |
| Frequency Multiplication | 01/01/70 00:00 | |
| what is the wave form shape of the original signal? | 01/01/70 00:00 | |
| Yes, PLL is the most promising solution | 01/01/70 00:00 | |
| Easy integer approximation | 01/01/70 00:00 | |
| Yes, but | 01/01/70 00:00 | |
| Wave Shape | 01/01/70 00:00 | |
| Constant speed? | 01/01/70 00:00 | |
| Constant speed? | 01/01/70 00:00 | |
| Constant speed? | 01/01/70 00:00 | |
| Constant speed? | 01/01/70 00:00 | |
| Still some outstanding questions | 01/01/70 00:00 | |
| Perhaps you're looking at the wrong motor | 01/01/70 00:00 | |
| Rate Multiplier | 01/01/70 00:00 | |
| That might work ... but ... | 01/01/70 00:00 | |
| Frequency multiplier | 01/01/70 00:00 | |
| How about some numbers? | 01/01/70 00:00 | |
| Frequency Multiplier | 01/01/70 00:00 | |
| I was afraid that was the case ... | 01/01/70 00:00 | |
| Frequency Multipllication | 01/01/70 00:00 | |
| What about that logic card? | 01/01/70 00:00 | |
| Frequency Multipiler | 01/01/70 00:00 | |
| Why no further relevant information? | 01/01/70 00:00 | |
I have been following this | 01/01/70 00:00 |