| ??? 05/04/10 06:03 Read: times |
#175646 - why load is there Responding to: ???'s previous message |
- on source pin of transistor.
Is there any special requirement to not place load on drain pin? Possible - Your circuit works well, problem is in circuit. |
| Topic | Author | Date |
| high current output SSR or opto | 01/01/70 00:00 | |
| Something like this perhaps? | 01/01/70 00:00 | |
| thank you | 01/01/70 00:00 | |
| Use due care... | 01/01/70 00:00 | |
| expansion | 01/01/70 00:00 | |
| Depends | 01/01/70 00:00 | |
| I agree | 01/01/70 00:00 | |
| Bleh! | 01/01/70 00:00 | |
| I caught that... | 01/01/70 00:00 | |
| half voltage | 01/01/70 00:00 | |
| why load is there | 01/01/70 00:00 | |
| Check These Items | 01/01/70 00:00 | |
| Load Placement | 01/01/70 00:00 | |
| Load placement | 01/01/70 00:00 | |
| thank you everyone | 01/01/70 00:00 | |
| 3 ohm load | 01/01/70 00:00 | |
| good advice | 01/01/70 00:00 | |
| If I understood your requiremnt properly have a look ULN2003 | 01/01/70 00:00 | |
I don't think so | 01/01/70 00:00 |