| ??? 06/07/10 11:44 Read: times |
#176470 - For discrete single I/O input and output Responding to: ???'s previous message |
Michael Karas said:
For discrete single I/O input and output use the RTS and CTS signals. That would be subject to the usual provisos for (ab)using RTS and CTS on RS232 ports in general and USB-to-Serial adaptors in particular... However, FTDI do have special drivers that allow some of their chips to be used in a properly-supported "bit-banged" mode - do you happen to know if this works with these cables? |
| Topic | Author | Date |
| Save time assembling prototype | 01/01/70 00:00 | |
| Step Further | 01/01/70 00:00 | |
| Instead of RS232... | 01/01/70 00:00 | |
| I use those too... | 01/01/70 00:00 | |
| For discrete single I/O input and output | 01/01/70 00:00 | |
| Special Driver.... | 01/01/70 00:00 | |
| Instead of 3x5pin headers | 01/01/70 00:00 | |
| At least one LED and an EEPROM too | 01/01/70 00:00 | |
| FTDI tools | 01/01/70 00:00 | |
| RE: a quite bizarre module | 01/01/70 00:00 | |
Absolutely Clever.... | 01/01/70 00:00 | |
| Status Led and Control Button | 01/01/70 00:00 | |
| why? | 01/01/70 00:00 | |
| Physical touch/looking | 01/01/70 00:00 | |
| No exra functionality | 01/01/70 00:00 | |
| Picture of back of daughterboard | 01/01/70 00:00 |