| ??? 06/30/13 05:36 Read: times |
#189972 - Snip first ? Responding to: ???'s previous message |
Joseph Hebert said:
Wonderful. Now I have to see if I can get this one off my new board without delaminating the pads. In cases like this, where the board matters more than the part, you can snip the leads, using a lift-then-snip walk-around. |
| Topic | Author | Date |
| Atmel Bootloader/Programming FLASH | 01/01/70 00:00 | |
| sounds ok | 01/01/70 00:00 | |
| Model # | 01/01/70 00:00 | |
| Snip first ? | 01/01/70 00:00 | |
| Snipping | 01/01/70 00:00 | |
| Have you considered using adapters? | 01/01/70 00:00 | |
| Removing ICs | 01/01/70 00:00 | |
| solder reflow station | 01/01/70 00:00 | |
| me too | 01/01/70 00:00 | |
AT89LP51Rx2 series ? | 01/01/70 00:00 |