| ??? 10/07/03 08:56 Read: times |
#56240 - simulation works, but not the real thing |
Hi all,
I simulated the following stepper motor driver using a software and it works fine.But when i tested the same by making a circuit, the stepper motor moves back and forth most of the times. This driver uses only 2 inputs to control a stepper. Every time the STEP signal goes low, the stepper should rotate one step in direction determined by DIR input. Is there anything i am doing wrong ? Regards 
|
| Topic | Author | Date |
| simulation works, but not the real thing | 01/01/70 00:00 | |
| RE: simulation works, but not the real thing | 01/01/70 00:00 | |
| RE: simulation works, but not the real thing | 01/01/70 00:00 | |
| RE: simulation works, but not the real thing | 01/01/70 00:00 | |
| RE: simulation works, but not the real thing | 01/01/70 00:00 | |
| RE: simulation works, but not the real thing | 01/01/70 00:00 | |
| RE: simulation works, but not the real thing | 01/01/70 00:00 | |
| RE: simulation works, but not the real thing | 01/01/70 00:00 | |
| RE: simulation works, but not the real thing | 01/01/70 00:00 | |
| microcontroller? | 01/01/70 00:00 | |
| RE: simulation works, but not the real thing | 01/01/70 00:00 | |
| RE: simulation works, but not the real thing | 01/01/70 00:00 | |
| RE: simulation works, but not the real thing | 01/01/70 00:00 | |
| Sequencer is wrong! | 01/01/70 00:00 | |
| Correction | 01/01/70 00:00 | |
RE: Correction | 01/01/70 00:00 |