Hello again =)

Ive build a test board to interface my
microcontroller with an IDE-ATA device
(currently a big fat slow cdrom drive)

But im not sure if ive got the timing
of the DIOW/DIOR (Device IO Write/Read)correct.
If im correct, these are the strobing
lines to strobe the data/commands in and out.

Is my sequence correct(?):

(reading from IDE device)
1. Setup DA0..DA2
2. Setup CS0, CS1
3. Strobe DIOR
4. Read Command/Data

Do i have to READ the value from the
IDE device while DIOR is still high?

Thanks in advance.