Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
08/22/05 16:10
Read: times


 
#99837 - m5450 code.
Responding to: ???'s previous message
Well I'm going to try and use it with 5x7 displays.

I think I've got some basic code right, but Im getting nothing out.
I'm not sure I've got the timing completely right. (the delays between "DATA In" and "CLOCK")

I'm also not an electronics guy so I may not have everything wired right.

Pin 1 grounded.
Pin 20 5 volts.
Pin 19 is wired to P1.1 (used that becasue I didn't know if I needed a full 5 volts there)
I've also actually got the m5451 so pin 23 is an output.

I put some led on the "Data" and "Clock" so I could see if something was actually getting to the chip and I believe it is.



List of 14 messages in thread
TopicAuthorDate
8051 m5450 code?            01/01/70 00:00      
   Re:            01/01/70 00:00      
   it would be helpful if you provided a fu            01/01/70 00:00      
      datasheet            01/01/70 00:00      
         I would be very weary of using this chip            01/01/70 00:00      
            m5450 code.            01/01/70 00:00      
               you will not get far with "believe", wha            01/01/70 00:00      
                  believe            01/01/70 00:00      
                  Can you review this?            01/01/70 00:00      
                     I'm using Bank 1            01/01/70 00:00      
                        Listing            01/01/70 00:00      
                           the using directive            01/01/70 00:00      
                              Bank 1            01/01/70 00:00      
                        Bank 1            01/01/70 00:00      

Back to Subject List