| ??? 08/15/06 20:54 Read: times |
#122309 - Thanks Erik - I'll give it a go Responding to: ???'s previous message |
I see a problem with this in my application, but it is worth a shot.
The issue I see is that it may be possible to have 2 "keys" active in a short space of time, so the first "key" triggers the interrupt. I then set it to look for no key so that I can see the release of the first key as you have suggested. However during that time the second key become active..... and I miss it, because I am currently waiting for the first key to be released before restoring the interrupt to it's "normal" look for keys state. There will be a sloution in their somewhere though, I have to think about it a bit more. Thanks for the clarification, I'll get back with what I find. Regards, Marshall |
| Topic | Author | Date |
| LPC 9xx Can't clear KBIF | 01/01/70 00:00 | |
| Turn it off? | 01/01/70 00:00 | |
| I could turn it off | 01/01/70 00:00 | |
| to turn the KBIF, you have to change the condition | 01/01/70 00:00 | |
| Thanks Erik - I'll give it a go | 01/01/70 00:00 | |
| an added comment | 01/01/70 00:00 | |
| What is the rate of change on the input signals? | 01/01/70 00:00 | |
| nothing of value except the ability to wake up the | 01/01/70 00:00 | |
| Interrupt for pulse train | 01/01/70 00:00 | |
| that's basically what the KBI does | 01/01/70 00:00 | |
| Rate of change ~<100kHz | 01/01/70 00:00 | |
| why not? | 01/01/70 00:00 | |
| I did not discuss | 01/01/70 00:00 | |
| It is ok but KBIF is set forever | 01/01/70 00:00 | |
| that you do not clear the reason | 01/01/70 00:00 | |
| I change the state of the pin before | 01/01/70 00:00 | |
| could be the problem | 01/01/70 00:00 | |
Simulators problem | 01/01/70 00:00 | |
| Remote Control using AT89C2051 schematic | 01/01/70 00:00 | |
| just great | 01/01/70 00:00 | |
| Another BS answer. | 01/01/70 00:00 | |
| No BS, I did | 01/01/70 00:00 |