| ??? 05/06/08 07:10 Read: times |
#154466 - Choosing big Capacitance values Responding to: ???'s previous message |
Erik Malund said:
If you put too much capacitance on Vcc
I have seen ZERO failures because of "too much capacitance on Vcc" (of course when a proper supervisor is used) and seen tons of failures becuse of "too little capacitance on Vcc". Now you re going to respond with your usual drivel, I am done with discussing supervisors with you. Erik Choosing big Capacitance values at Vcc , does slows down the circuit response time . Though I am not sure what corruption it may lead to but its a fact . You can see Atmel site for further readings. -Ap |
| Topic | Author | Date |
| LCD Problem | 01/01/70 00:00 | |
| Read the data sheets carefully | 01/01/70 00:00 | |
| add el.capacitor 10..100 microF close to LCD | 01/01/70 00:00 | |
| a common "mistake" | 01/01/70 00:00 | |
| please, not again | 01/01/70 00:00 | |
| You just don't like the facts, Erik ... | 01/01/70 00:00 | |
| Choosing big Capacitance values | 01/01/70 00:00 | |
| response time? | 01/01/70 00:00 | |
| LCD Problem !!!! | 01/01/70 00:00 | |
| Have you tested Joe\'s procedure? | 01/01/70 00:00 | |
| so post Your sourcecode | 01/01/70 00:00 | |
Write your initialization code in ASM! | 01/01/70 00:00 |