Hi,

I'm not using the AD2000 assembler, but thanks anyway.
I have another question though - in the data sheet for the OKI 80C154 it says that when using Timer 2 as a baud rate generator that the baud rate is as follows:

Baud = Xtal * (1/(65536 - DRCAP2)) * (1/16)

but most other sources seem to say that it is

Baud = Xtal * (1/(65536 - DRCAP2)) * (1/32)

I'm inclined to believe the data sheet, but would like verification before I burn another EPROM (I don't yet have an eraser :( ).
Also, do the reload values need to exactly match the baud rate? or is a small error ok?

Cheers for any help,

George Ricketts