Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread
???
07/12/04 13:00
Read: times


 		 #74041 - RE: Spliting a design on two boards.
Responding to: ???'s previous message
I just recall one reason I once split a design on 2 boards. Fine pitch components are not good candidates for bords with thick copper layers and I needed fine pitch and 20A traces. The rigtht way was to put the fine pitch on one board and the 20A stuff onh another.

Erik

List of 21 messages in thread
TopicAuthorDate
Spliting a design on two boards.            01/01/70 00:00      
   RE: Spliting a design on two boards.            01/01/70 00:00      
      RE: Spliting a design on two boards.            01/01/70 00:00      
   Mismatch about number of posts            01/01/70 00:00      
      RE: Mismatch about number of posts            01/01/70 00:00      
   RE: Spliting a design on two boards.            01/01/70 00:00      
      RE: Spliting a design on two boards.            01/01/70 00:00      
         RE: Spliting a design on two boards.            01/01/70 00:00      
         Design on two boards.- Russell            01/01/70 00:00      
            RE: Design on two boards.- Russell            01/01/70 00:00      
               RE: Design on two boards.- Russell            01/01/70 00:00      
               RE: Design on two boards.- Russell            01/01/70 00:00      
            RE: Design on two boards.- Russell            01/01/70 00:00      
      RE: Spliting a design on two boards.            01/01/70 00:00      
         RE: Spliting a design on two boards.            01/01/70 00:00      
         RE: Spliting a design on two boards.            01/01/70 00:00      
            RE: Spliting a design on two boards.            01/01/70 00:00      
               RE: Spliting a design on two boards.            01/01/70 00:00      
      Common mode filtering is needed!            01/01/70 00:00      
   RE: Spliting a design on two boards.            01/01/70 00:00      
      RE: Spliting a design on two boards.            01/01/70 00:00      

Back to Subject List