Email: Password: Remember Me | Create Account (Free)

Back to Subject List

Old thread has been locked -- no new posts accepted in this thread

??? 01/21/05 09:04 Read: times	#85472 - I meant crystall at 4 Mh. Responding to: ???'s previous message
	Crystall at 4 Mh.

List of 34 messages in thread

Topic	Author	Date
Need programmer for DS89C430 & DS80C310		01/01/70 00:00
The datasheet for 430 says:		01/01/70 00:00
Or use a terminal program		01/01/70 00:00
... or do it the easiest way...		01/01/70 00:00
It works fine		01/01/70 00:00
Errata!		01/01/70 00:00
Does NOT work!!!Help!		01/01/70 00:00
Or can you tell me		01/01/70 00:00
DS89C420 ISP		01/01/70 00:00
Or maybe		01/01/70 00:00
I meant crystall at 4 Mh.		01/01/70 00:00
NOOOO		01/01/70 00:00
Did you look at PCB Layout?		01/01/70 00:00
No		01/01/70 00:00
I don't understant much		01/01/70 00:00
Heelpp!!		01/01/70 00:00
bad title, bad link		01/01/70 00:00
DS89C4x0 ISP		01/01/70 00:00
About the link		01/01/70 00:00
Link works here		01/01/70 00:00
Link		01/01/70 00:00
same place		01/01/70 00:00
Link again		01/01/70 00:00
Back to the main issue...		01/01/70 00:00
No scope,		01/01/70 00:00
But this is the FULL circuit diagram		01/01/70 00:00
use something else		01/01/70 00:00
Oh no it isn't		01/01/70 00:00
Look at the bottom		01/01/70 00:00
but..		01/01/70 00:00
Cap on Pin 2 to connected Vcc		01/01/70 00:00
which goes to show.....		01/01/70 00:00
You 're right		01/01/70 00:00
Make a start.		01/01/70 00:00

Back to Subject List