My question is, how does it get into program mode The idea in NoTouch is to answer that question with "any which way you want"

You can activete the 10 or so lines of code that NoTouch comprises by recognizing a recoed on the UART, holding a pin high or low or pressing a key combination or WHATEVER. NoTouch does not handle activation, it is a few lines YOU activate.

I, personally, activate by a special record on the UART, that way I can put all that is needed in a commandfile.

(I know, I know RTFM)... correct re Flash<Magic, re NoTouch it is difficult to read a manual that does not exist. The closest you can get to a NoTouch manul is to read the NoTouch entry in my user page, but for a 932, you must use the NoTouch for 935 by someone else that is on the FlashMagic web.

Erik

Again, since the chip arrives in ISP mode no special concern is required to install NoTouch in the code. "The backdoor" is a suggestion for activating even when your developemnet result in code that can not reach your NoTouch activation.