| ??? 05/20/05 07:43 Read: times |
#93631 - Freeze spray Responding to: ???'s previous message |
Note that there cans with freeze spray readily available (just type "freeze spray" into Google) which allow you to cool single components to approx. -45 degrees C. You could get one and cool your components one by one. Then if the board suddenly seizes up, you know you are busy cooling the guilty component. Best used in combination with a hot air blower to heat stuff back up again. (They're both must-haves for any electronics enthusiast or professional alike.)
|
| Topic | Author | Date |
| Temperature and 89C2051 | 01/01/70 00:00 | |
| Chip Grade? | 01/01/70 00:00 | |
| A bit vague | 01/01/70 00:00 | |
| oscillator? | 01/01/70 00:00 | |
| Built-in Pierce oscillators ARE reliable | 01/01/70 00:00 | |
| Freeze spray | 01/01/70 00:00 | |
| Overheated parts, too hot soldering? | 01/01/70 00:00 | |
| I have my doubts | 01/01/70 00:00 | |
| What about this? | 01/01/70 00:00 | |
| has happened | 01/01/70 00:00 | |
| Re: has happened | 01/01/70 00:00 | |
| Microwave oven | 01/01/70 00:00 | |
| not microwave, but toaster oven | 01/01/70 00:00 | |
| Thanks for replies | 01/01/70 00:00 | |
| How about this | 01/01/70 00:00 | |
| Wait a minute... | 01/01/70 00:00 | |
| Improvements | 01/01/70 00:00 | |
| resist | 01/01/70 00:00 | |
| Quartzes, etch resist | 01/01/70 00:00 | |
| Quartz Crystals | 01/01/70 00:00 | |
| Quartz crystals | 01/01/70 00:00 | |
no problem | 01/01/70 00:00 | |
| Maybe! | 01/01/70 00:00 | |
| Maybe! | 01/01/70 00:00 | |
| LED temperature rating? | 01/01/70 00:00 |