| ??? 08/21/05 06:14 Read: times |
#99760 - Alternative Responding to: ???'s previous message |
Thanx Erik.
I am stuck with the plastic enclosure. Its for this reason I choose the 4 layer PCB. I will use every second wire in the ribboncable as ground and have a separate thick wire too. I did think of an alternative way: I'll keep the realys, their flywheel diodes and RC circuit on the PSU board with the mains power, but move the driver transistor to the board with the micro and other stuff. That way I wont have any low level (TTL) wires rounning around - only 24V lines. My concern is relay noise induced in the other electronics. Well - the weekend is almost over, so - ha en god søndag Per |
| Topic | Author | Date |
| driving ribboncabel - ESD precautions | 01/01/70 00:00 | |
| on interconnect | 01/01/70 00:00 | |
| Alternative | 01/01/70 00:00 | |
| comments. | 01/01/70 00:00 | |
| Recommended scheme | 01/01/70 00:00 | |
| 74H? | 01/01/70 00:00 | |
| nope | 01/01/70 00:00 | |
| Don't forget series termination | 01/01/70 00:00 | |
| series termination | 01/01/70 00:00 | |
| re: series termination | 01/01/70 00:00 | |
| an, in my opinion, much better way is to | 01/01/70 00:00 | |
| Series termination is the correct method | 01/01/70 00:00 | |
| both? | 01/01/70 00:00 | |
| Series termination prevents overshot | 01/01/70 00:00 | |
| HUH? | 01/01/70 00:00 | |
| Huh Huh? | 01/01/70 00:00 | |
| read the original post | 01/01/70 00:00 | |
| Think about the newbies | 01/01/70 00:00 | |
| That is exacltly why I always push the u | 01/01/70 00:00 | |
| RS485 is a good alternative, indeed | 01/01/70 00:00 | |
| Use a relay driver and sleep well ... | 01/01/70 00:00 | |
ferite bead, series termination, or | 01/01/70 00:00 |