| ??? 02/29/08 10:49 Read: times |
#151663 - Quadrature Encoder interfacing |
I'm interfacing to old quadrature encoder with differential outputs. Can I use the MAX485 to read the differential channels?
Any other suggestions for line receiver ic with 2 channels? I have no datasheet for the encoder but the wiring diagram is marked on the encoder itself. To minimize number of chips used can I tie one end of the differential output to Gnd and use the other pin since the distance from the encoder to ucontroller is about 1 meter with sheilded cable? The encoder's Vcc is rated 5VDC. Mahmood |
| Topic | Author | Date |
| Quadrature Encoder interfacing | 01/01/70 00:00 | |
| Use interrupt | 01/01/70 00:00 | |
| it does NOT work | 01/01/70 00:00 | |
| 'differential' is more than obe thing | 01/01/70 00:00 | |
| Why does clock/direction fail ? | 01/01/70 00:00 | |
| I got it ..... | 01/01/70 00:00 | |
| a quadrature detector .... | 01/01/70 00:00 | |
| Possibly differential | 01/01/70 00:00 | |
| if so, then datasheet would be needed or | 01/01/70 00:00 | |
| Datametrics | 01/01/70 00:00 | |
| need that scope picture (description) | 01/01/70 00:00 | |
| Decoder timing diagram | 01/01/70 00:00 | |
| Scope Waveforms | 01/01/70 00:00 | |
| 485 will be fine, I suggest LT1785 | 01/01/70 00:00 | |
| My original question | 01/01/70 00:00 | |
| Encoders With Differential Outputs | 01/01/70 00:00 | |
| IC Chip Decoder Solutions | 01/01/70 00:00 | |
Project details | 01/01/70 00:00 |