| ??? 12/08/08 17:16 Modified: 12/08/08 17:20 Read: times |
#160741 - Partial success... Responding to: ???'s previous message |
OK, I can download a Metalink .DBG file, and open the corresponding .asm source file in Silabs. I can see the registers etc, and trace through the assembler. However, if I try to set a breakpoint I get a message "No address correlation for line number XX", even though the trace through the source works fine.
edit>> Smiliarly to here ( http://www.cygnal.org/ubb/Forum1/HTML/000090.html ) I can add a breakpoint using an address. Getting there I guess? |
| Topic | Author | Date |
| Need some advise on Silabs development in assembler... | 01/01/70 00:00 | |
| OMF-51? | 01/01/70 00:00 | |
| Not sure what you mean... | 01/01/70 00:00 | |
| I can't see why not... | 01/01/70 00:00 | |
| Found it! | 01/01/70 00:00 | |
| assembler | 01/01/70 00:00 | |
Thanks Maarten. | 01/01/70 00:00 | |
| SDCC | 01/01/70 00:00 | |
| just curious | 01/01/70 00:00 | |
| I believe | 01/01/70 00:00 | |
| I hope so... | 01/01/70 00:00 | |
| Try the Metalink Assembler | 01/01/70 00:00 | |
| Thanks... | 01/01/70 00:00 | |
| does anyone have the install file for Silabs pre 1.3? | 01/01/70 00:00 | |
| Your Keil Understanding | 01/01/70 00:00 | |
| objcopy info | 01/01/70 00:00 | |
| That may be difficult | 01/01/70 00:00 | |
| That's good enough... | 01/01/70 00:00 | |
| Partial success... | 01/01/70 00:00 | |
| a guess | 01/01/70 00:00 | |
| Yes. | 01/01/70 00:00 |